Carpenter CTS-204P Knife Steel
Composition Analysis Graph, Equivalents And Overview

CTS-204P(Carpenter) - Carpenter's equivalent of Bohler-Uddeholm M390 steel and Latrobe Duratech 20CV steel. Slightly more Tungsten(W) 0.65% instead of 0.60% in other two. As for the manufacturing process, Carpenter's gen 2 process should produce as fine powder as Bohler-Uddeholm's Gen 3 PM does. In other words, generation numbers are specific to specific steel maker, and not directly comparable. CTS-204p features very high wear and corrosion resistance. Fine grained alloy, popular choice for high end folders and small fixed blades. working hardness up to 62HRC. Excellent performance with both, coarse and high polished edges. You still need about 15° per side edge to get the best performance and edge holding. Thinner than that, and you will run into the issue with the thin edge not being able to support all those carbides to make the edge perform. Working hardness can reach 62HRC, and most of the production knives I've seen are in 60-62HRC range. Overall, it is of the best performers as far as corrosion and wear resistance go, and because of that it is a popular choice for high end, and the limited edition knives. Aside from very good edge holding ability, maintaining the edge is very easy. And one more thing worth noticing, there's no stubborn burr forming during sharpening, therefore, there's no risk to form a wire edge either.

Manufacturing Technology - MM

Country - United States(US)

Known Aliases:
Carpenter - Micro-Melt 20-4p